MIL-H-80055B
Standard equipment, if different (see 3.7.1).
t.
u.
Optional equipment, if required (see 3.7.2).
V.
Suppression of radio interference, if required (see 3.8).
Moisture and fungus treatment, if required specify (see 3.9).
w.
x.
Portability, if different (see 3.10).
First article inspection, if different (see 4.3).
y.
Quality conformance inspection, if different (see 4.4).
z.
Preparation for delivery, if different (see 5.1).
aa.
* 6.2.2 Contract data requirements. Required technical data, such as
operators manuals, parts lists, wiring diagrams, and other instructions
for operation and maintenance as identified on a numbered DD Form 1664
should be specified on a DD Form 1423 incorporated into the contract.
* 6.3 First article. When a first article is required, it shall be tested
and approved under the appropriated provisions of 7-104.55 of the Defense
Acquisition Regulation. The first article should be a preproduction sample,
or a standard production item from the contractor's current inventory. The
contracting officer should include specific instructions in all procurement
instruments regarding arrangements for examination, test and approval of the
first article.
* 6.4 Safety and health requirements. Paragraph 3.2.3 requires compliance
only with those OSHA requirements that concern the machine itself. It does
not require compliance with those OSHA requirements that concern "the machine
in its operating environment" such as noise levels, radiation levels, electro-
magnetic emissions, noxious vapors, air contaminants, in the environment.
(Does not limit the hazard level of individual machine in the environment).
The procuring agency is advised to analyze the existing hazards levels in the
proposed operating environment, and specify additional machine requirements
that will integrate the new machine into its future operating environment.
If specific point-of-operation guarding is required, the procuring agency
should specify the exact configuration of the guard required. The above, and
any other additional safety and health requirements should be specified in
detail under 6.2.1.e.
6.5 Changes from previous issue. The margins of this specification are
marked with asterisks to indicate where changes, additions, modifications,
corrections, deletions from the previous issue were made. This was done as
a convenience only, and the Government assumes no liability whatsoever for
any inaccuracies in these notations. Bidders and contractors are cautioned
to evaluate the requirements in this document based on the entire content
irrespective of the marginal notations and relationship to the previous issue.
16
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business